Battery Charging; Connecting The Charger; Connecting Battery To Charger; Final Flight Preparation - J. Perkins Twister 3D Storm User Manual

BATTERY CHARGING

11. CONNECTING THE CHARGER

•
The included balancing type charger come
with both an AC power adaptor and a
power lead for 12VDC operation.
•
Plug the connector from the AC power
adapter or the 12VDC power lead into the
socket on the right hand side of the
charger. See below:
•
With the power to the charger turned on,
the red 'Charge' LED will flash and the
'cell' LED's will be solid red.
12. CONNECT BATTERY TO
CHARGER.
•
Connect the balance plug on the battery
into the side of the charger. See below:
http://www.jperkinsdistribution.co.uk
•
The 'Charge' LED should be solid red while
the 'Cell' LED's will be solid green or solid
orange depending on the state of the
battery cells. The instructions on the front
of the charger give full details on the LED
indicators and the battery charge status.
•
When all four LED's are solid red, the
battery is fully charged.
WARNING!
•
Do not leave battery unattended when
charging
•
Do not attempt to charge a warm
battery. Allow battery to cool before
charging.
•
Disconnect battery immediately should
battery become hot to touch.

FINAL FLIGHT PREPARATION

13. INSTALLING THE BATTERY.

•
Slide the battery into the battery cavity be-
neath the motor and secure with the Velcro
strap provided. See below:
WARNING!
Keep hands, clothing, eyes, animals and chil-
dren well clear when connecting power to
this model and when flying it!
http://www.modelengines.com.au
Twister 3D Storm