Switching The Push/Start Aid On/Off; Switching Bike Lights On/Off - Bosch Nyon Operating Instructions Manual

Switching the Push/Start Aid On/Off

With the speed version, the push aid can also be used as a start aid. The
start aid is switched off at 18 km/h.
The push/start aid can make it easier for you to push or start the eBike. The
speed of this feature depends on the selected gear and depending on the
model, can reach a maximum of 6 km/h or 18 km/h. The lower the selected
gear, the lower the speed of this function (at full capacity).
 The push/start aid function may only be used when pushing or
starting the eBike. If the wheels of the eBike have no contact with the
ground when using the push aid, then there is risk of injury.
To switch on the push/start aid, press and hold the "WALK" 16 button on
the operating unit. The eBike drive is switched on.
The push/start aid is switched off if one of the following occurs:
– you release the "WALK" 16 button,
– the wheels of the eBike are blocked (e.g. by actuating the brakes or
impacting against an obstacle),
– the speed exceeds 6/18 km/h.

Switching bike lights on/off

In the model, in which the lighting is powered by the eBike system, the
front and rear light can be switched on and off at the same time via the on-
board computer with the button 6.
The illumination symbol s1 is displayed when the light is on.
Switching the bike light on and off has no effect on the back lighting of the
display.
Bosch eBike Systems
English – 33
W 276 001 DPNen | (21.8.15)