Basic Operation; Basic Operation Of This Unit; Turning On The Power; Selecting An Input Source - Yamaha CRX-D430 Owner's Manual

Basic operation of this unit

Turning on the power

Press 1 STANDBY/ON (or A STANDBY/ON) to
turn on this unit.
Press it again to set this unit to the standby mode.
y
• You can select whether to display the clock (ECO OFF mode)
or not (ECO ON mode) when this unit is in the standby mode.
Press and hold I TIME MODE during standby mode until
"ECO OFF" or "ECO ON" appears.
• To charge your iPod while this unit is in the standby mode,
select "ECO OFF".
• The memory back-up circuit prevents the clock setting from
being lost even if this unit is in the standby mode. However, the
clock setting will be lost if the power cable is disconnected from
the AC wall outlet or if the power supply is cut off for more than
four minutes.
• In the standby mode, this unit consumes a small amount of
power.

Selecting an input source

Press one of the input selector buttons (2)
repeatedly (or press N INPUT) to select the
input source from CD, iPod, TUNER (FM/AM/
DAB), and AUX.
• Press DBAND (or E BAND) to select FM, AM, or
DAB.
• For details on CD, iPod, and tuner operations, refer to
pages 8, 10, 12, and 14.
• When you select AUX, this unit outputs sound played
back on the component which is connected to the AUX
IN jacks. While AUX is selected as the input source,
this unit does not output signals at the AUX OUT
jacks.

Adjusting the volume level

Press K VOLUME + (or rotate O VOLUME
clockwise) to increase the volume level and
press KVOLUME – (or rotate it counter-
clockwise) to decrease it.
Muting the sound
Press LMUTE.
To restore audio output to the previous volume level, press
it again or press KVOLUME +/–.
6
En y The circled numbers and alphabets correspond to the ones on the attached sheet.
Basic operation of this unit

Adjusting sounds

Press I FUNCTION (or K FUNCTION).
1
2
Press 0
/ repeatedly (or rotate the
multi jog dial ( J )) to select the setting from
"Bass" (low frequency), "Treble" (high
frequency), and "Balance" (speaker balance),
and then press 0ENTER (or push the multi
jog dial ( J )).
3
Press 0
/ repeatedly (or rotate the
multi jog dial ( J )) to adjust the setting and
then press 0 ENTER (or push the
multi jog dial ( J )).
The setting ranges are as follows:
Bass ..................... –10 dB to +10 dB
Treble................... –10 dB to +10 dB
Balance ................ L +6 to R +6
Note
These settings have no effect on the audio signals output at the
AUX OUT jacks and the DIGITAL OPTICAL OUT jack.

Listening through the headphones

Connect the headphone plug to the H PHONES
jack.
y
While headphones are connected, the sound from the speakers
and subwoofer is cut off.
Changing the brightness of the
display
Press 4 DIMMER repeatedly.
You can select the brightness level from bright, mid dim,
and dim.