Basic Operation; Playback; Basic Procedure; Using The Scene Function - Yamaha RX-V665 Owner's Manual

BASIC OPERATION

Basic procedure

1
Turn on external components (TV, DVD
player, etc.) connected to this unit.
2
Press OINPUT l / h (or hInput
selection keys) to select an input source.
The name of the selected input source is displayed for
a few seconds.
Input source name
AV1
y
• You can change the input source name displayed on the front panel
display or the OSD on the video monitor as necessary (see
page 46).
3
Play the external component that you have
selected as the source input, or select a radio
station on the tuner.
Refer to the operating instructions of the external
component for details on playback. For selecting
radio stations or playback of an iPod or Bluetooth
component using this unit, see the following.
• FM/AM radio tuning (see page 29)
• Bluetooth component playback (see page 33)
• iPod playback (see page 31)
4
Turn the QVOLUME control to adjust the
volume (or press pVOLUME +/–).
Volume -18.5dB
Note
When you play back a DTS-CD, noise may be output in some
conditions, which may cause a speaker malfunction. Make sure
that the volume is set to low before starting playback. If noise is
output, do the following.
1) When only noise is output
If a DTS bitstream signal is not properly input to this unit,
only noise is output. Connect the playback component to this
unit by digital connection and play back the DTS-CD. If the
condition is not improved, the problem may results from the
playback component. Consult the manufacturer of the
playback component.
2) When noise is output during playback or skip operation
Before playing back the DTS-CD, display the option menu
after selecting the input source and set "Decoder Mode" to
"DTS" (see page 34).
22
En

Playback

Using the SCENE function

This unit has a SCENE function that allows you to change
input sources and sound field programs with one key. Four
scenes are available for different usages, such as playing
movies or music. The following input sources and sound
field programs are provided as the initial factory settings.
BD/DVD
TV
CD
VOL.
RADIO
y
• When this unit is on standby, you can turn on this unit by pressing the
SCENE key.
• When connecting a Yamaha DVD/CD player that has the REMOTE OUT
jack of this unit, you can play back a DVD/CD on the player by selecting
BD/DVD or CD SCENE function.
Selecting a SCENE
Press JSCENE (or lSCENE).
Registering input source/sound field
program
Select the desired input source/sound field
program, and press down JSCENE (or
lSCENE) until "SET Complete" appears on the
front panel display.
While display in the OPTION menu or SETUP menu,
Volume
"SCENE Setting Complete" appears on the video monitor
VOL.
(OSD).
SW
C
L R
Switching remotely controlled external
SL SR
components linked to scene selections
You can operate an external component with the remote
control of this unit by setting a remote control code for the
external component for each input source. Setting remote
control codes for desired input sources allows you to
switch between external components linked to scene
selections.
1
Input source
HDMI 1
AV 1
AV 3
TUNER
Register the remote control code of an
external component to the desired input
source (see page 50).
Note
• Remote control codes cannot be registered to TUNER input.
Sound field program
Straight
Straight
Straight
7ch Enhancer