I60" Code Family: Heating Element Problems; I70" Code Family: Ntc Problems; I90" Code Family: Configuration Problems; Ib0" Code Family: Turbidity Sensor Problems - Electrolux ProClean RealLife EDW5xx Series Service Manual

9.2.6.10 "i5A" – washing pump over temperature
- an internal warning is defined when the internal calculations based on the currents lead us to
assume that the temperatures are outside the standard limits (200 °C - with 40 °C margin due to
measurement and calculation tolerances).
- The alarm is signalled if the value is more than the threshold of 178 °C.
9.2.7

"i60" code family: Heating element problems

9.2.7.1 "i60" code – heating element
- The alarm is stored and displayed only in service mode; the washing programme continues without
the activation of the heating element.
- During the heating phases, the rise in temperature is monitored with an update every 3 min.
- Within these 3 minutes, the temperature must rise by at least 1 °C.
9.2.7.2 "i61" code – heating element in over temperature
- If the temperature of the water detected is more than 78 °C, the cycle is suspended.
9.2.8

"i70" code family: NTC problems

9.2.8.1 "i70" code
- The alarm is stored and displayed only in service mode; the washing programme continues without
the activation of the heating element.
- Monitoring starts immediately after the programme has been started.
- The voltage measured at the ends of the NTC must be between 0.04 and 4.7 V.
- Time limit set: 10 sec.
9.2.9

"i90" code family: Configuration problems

9.2.9.1 "i91" code
- No washing programme start is possible, can be resolved by turning the appliance off and back on
again.
- The display board does not satisfy the identification requests of the main board.
9.2.9.2 "i92" code
- The alarm is signalled if the configuration control of the washing cycles provided erroneous results.

9.2.10 "iB0" code family: Turbidity Sensor Problems

9.2.10.1 "iB0" code - turbidity sensor
- The alarm is displayed if the calibration procedure is not completed after 15 sec.
- The washing programme will run as though the dirt value to be considered is high.

9.2.11 "iC0" code family: Communication problems

9.2.11.1 "iC0" code – display board communication
- The error signal is displayed if the communication system does not recognise any display board.
9.2.11.2 "iC1" code
- After three attempts to establish communication, an error is signalled in the hardware control.
SOE/PR 32 599 72 48-93