User Mode Settings; Entering The User Mode - Electrolux ProClean RealLife EDW5xx Series Service Manual

6 User Mode Settings

6.1

Entering the User Mode

You can enter this Mode by pressing the two configured buttons simultaneously for at least 2 sec after
the appliance has been turned on and is on stand-by without any selected programme:
with EDW1xxx-2G display boards: by pressing buttons S2+S3.
with EDW3xxx display boards: from the options menu.
You can quit User Mode by turning off the appliance or after a 60 sec timeout.
When this mode is enabled, it is indicated by the flashing of the LEDs corresponding to the buttons available
in this mode. The User mode is incorporated into the options menu on the displays.
Example for a 3-digit display:
For the EDW750, set the knob to a position without a washing cycle indication, as shown in the
figure, and press buttons S1+S2 simultaneously for a few seconds.
For the EDW1850-1950, you can enable it by pressing the two configured buttons simultaneously for
at least 2 sec after the appliance has been turned on and is on stand-by without any selected programme:
For the EDW1953 TOUCH, you can enable it by pressing the two configured buttons simultaneously
for at least 2 sec after the appliance has been turned on and is on stand-by without any selected
programme:
SOE/PR
1. 1. 2. 2.
12 599 72 48-93