Jet PRSWSH-1316PTL User Manual page 9

Fitting the Wheels and rubber feet (if equipped)
NOTE! Some models come with Rubber feet already fixed to the frame.
The following step must be completed for each of the two wheel/axle sets.
Attach axle to wheels (some models are different)
1. Installing one side at a time simply slide one wheel onto the axle followed by one washer, pass the split pin
through the axle and bend the legs out and around the axle as shown.
Attach wheels to frame
1. Insert the Wheel Axle into the Frame Axle Tube.
2. The Locking Groove should align with the Bolt.
3. Tighten the Bolt.
4. Repeat this process to attach the 2nd wheel to the other side of the frame.
Attach rubber feet to frame
1. Attach rubber feet to frame.
2. Rubber foot: Install with a washer and a type 2 nut.
180714125800
8
8