Assembly - Jet PRSWSH-1316PTL User Manual

Assembly

10hp+ machines only - Fitting the vent plug
INFORMATION! The shipping plug is a sealed plug used to prevent oil leaking during shipping and must be
replaced with the vent plug before use. The "vent plug" allows any pressure that builds up to escape while in use.
DO NOT operate this machine until the shipping plug has been removed and the "vent plug" is installed.
With the engine perfectly level:
1. Remove the "shipping bolt" (A) from the top of the water pump.
2. Screw the "vent plug" (B) in place of the "shipping bolt" (A).
This pump comes with pre-filled gear oil. For transportation purposes, it comes sealed. Please see below steps
for installing the breather plug.
Step 1: Ensure that the engine is upright and on even ground.
Step 2: Remove 8mm hex screw cap.
Step 3: Screw on red breather plug.
180714125800
8mm HEX cap Breather plug
7
7