Jet PRSWSH-1316PTL User Manual page 10

Fitting the handle and hose holder (if equipped)
NOTE! Some models come fitted with a hose reel.
Handle (if equipped)
Push the handle down into the tube ends on the pressure washer frame as illustrated below.
Hose Holder (if equipped)
1. Insure a Nut has been threaded onto each side of the Hose Holder (image 1).
2. Insert the Hose Holder through the frame joining holes as illustrated in (image2).
3. Complete this step by carefully tightening the correct nuts onto the end of the Hose Holder (image2).
Gun and Lance Holder Hook
1. Insure a Nut has been threaded onto the "Gun/Lance holder hook" (image 1).
2. Insert the "Gun/Lance holder hook" through the frame holes as illustrated in (image2).
3. Complete this step by carefully tightening the correct nuts onto the end of the Hose Holder (image 3)
180714125800
9
9