Rear Panel - AOR ARD9900 Instruction Manual

Fast radio modem multi-mode and digital voice interface
Hide thumbs Also See for ARD9900:
Table of Contents

Advertisement

7. MIC GND ----------------
8. MIC IN --------------------

Rear Panel

AOR,LTD.
k. Communication Connector (mini DIN 8 pin)
Connector to PC (RS-232C)
Pin Number
1
2
3
4
5
6
7
8
Shell
Baud Rate
Data bit
Start bit
Stop bit
Parity
Synchronisation
Flow control
l.
VIDEO - IN connector
NTSC or PAL depending on country of purchase, 1V p – p, 75 ohm (RCA type
connector).
Connect a video signal source such as a video camera, VCR output, etc.
m.
VIDEO – OUT connector
NTSC or PAL depending on country of purchase 1V p – p, 75 ohm (RCA type
connector).
Connect a video monitor to this connector to monitor a received image or a picture to be
sent.
n.
RADIO Connector
The pin connections of this port conform to those used by the manufacturer Adonis and
many of the current amateur radio transceivers are catered for by ready made cable
assemblies available from AOR. Otherwise, use the supplied 8-pin connector to connect
the ARD9900 to your radio equipment.
You will need to wire a cable according to the microphone connector specifications of your
radio.
Below are the pin assignments of the connector on the ARD9900:
Microphone ground signal.
Microphone signal input.
VIDEO
IN
OUT
l
k
m
Signal
TX
DTR
DSR
GND
RX
RTS
CTS
NC
FG

OUT
SP
IN
RADIO
o
n
p
Signal Direction
ARD9900----->PC
ARD9900----->PC
ARD9900<-----PC
GND
ARD9900<-----PC
ARD9900----->PC
ARD9900<-----PC
No Connection
Frame ground
9600
8
1
1
None
Asynchronous
Hardware
-
+
DC IN
q
r

Advertisement

Table of Contents
loading

Table of Contents