Removing the Monitor Stand
You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION:
power, signal, and network cables are all disconnected. Also disconnect all USB cables connected to
the monitor.
1.
Disconnect and remove all cables from the monitor.
2.
Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3.
Press down on the latch near the bottom center of the monitor to unlock the HP Quick Release 2
(1).
4.
Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).
5.
Slide the stand out of the recess (3).
18
Chapter 3 Setting Up the Monitor
Before beginning to disassemble the monitor, be sure the monitor is turned off and the