Device Settings - Sony HVO-500MD Instruction Manual

The tonal range for [Limited Range] is 16 to 235, and
the tonal range for [Full Range] is 0 to 255.
The default setting is [Full Range].
[Auto Index]
Select whether to automatically insert index marks
when recording.
The default setting is [Not Used].
Index marks are inserted every 5 minutes when [Use]
is selected.
[Pre-Rec]
Select whether to perform pre-rec.
The default setting is [Not Used].
[HPD sink interlock]
Select whether to link the HPD (hot plug detect) sink
of the device connected to the HDMI IN connector to
the source device.
The default setting is [Use].
Note
If the sink device is disconnected or turned off while
recording is in progress, the recording may be
interrupted accordingly.
3
To configure settings in other tabs, use the V , v , B ,
and b buttons to select a tab.
If you are finished configuring [Function Settings],
use the V , v , B , and b buttons to select [Apply], and
press the ENTER button to save the configurations.
62

Device Settings

Device Settings
Configure settings for external devices.
1
In the [System Admin Settings] screen, use the V , v ,
B , and b buttons to select [Device Settings], and press
the ENTER button.
The [Device Settings] screen appears.
2
Use the B and b buttons to select a tab, and configure
settings as necessary.
For details on each tab, see the following.
"[Device] Tab" (page 63)
"[Contact Switch] Tab" (page 64)
3
When you finish configuration, use the V , v , B , and b
buttons to select [Apply], and press the ENTER
button.
The configurations are saved, and the [System Admin
Settings] screen appears again.