Sony HVO-500MD Instruction Manual page 66

1 Use the V and v buttons to select the [Control
Monitor] box, and press the ENTER button.
The [Control Monitor] screen appears.
2 Use the V and v buttons to select [Use], and press
the ENTER button.
The [Contact Switch] tab appears again.
3 Use the B and b buttons to select [Advanced], and
press the ENTER button.
The [Advanced] screen appears.
66
Device Settings
4 Use the V and v buttons to select the setting you
want to configure, and press the ENTER button.
The default setting is [Not Controlled].
[Device Input]
Configure this to output images from devices such
as ultrasonography equipment onto the monitor.
[Recorder Input]
Configure this to output images from this unit onto
the monitor.
[Tally Lamp]
Configure this to indicate the recording status via
the tally lamp on the monitor.
The pin assignment screen appears.
5 Use the V and v buttons to select a pin number, and
press the ENTER button.
From the eight pins on the monitor connector,
assign one pin each for camera signal inputs (image
inputs from devices such as ultrasonography
equipment), recorder signal inputs (image inputs
from this unit), and the recording status tally lamp
(tally lamp on/off).
Tips
• Pin number 5 is reserved for GND and cannot be
selected.
• The same pin number cannot be configured for
contact switches 1 and 2.
• Pin assignment settings will vary depending on
the monitor. Refer to the operating instructions
for your monitor.
The [Advanced] screen appears again.