Alarm - Panasonic KX-TGF350C Operating Instructions Manual

Programming
Main menu: "Key detector"
Sub-menu 1
Search
Battery check
*1 If you program these settings using one of the units, you do not need to program the same item using
another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in direct
command code.
*3 This feature allows the unit to automatically adjust the date and time each time caller information
including date and time is received.
To turn this feature on, select "Caller ID auto". To turn this feature off, select "Manual". (Call
Display subscribers only)
To use this feature, set the date and time first (page 13).
*4 The preset melodies in this product ("Tone 3" - "Melody 10") are used with permission of © 2009
Copyrights Vision Inc.
*5 If you subscribe to a distinctive ring service, select a tone (tone 1 or 2). If you select a melody, you
cannot distinguish lines by their ringers.
*6 Handset
*7 Base unit
*8 This setting is available when you have the key detector (KX-TGA20). Read the installation manual
for more information on the key detector.
*9 For models with supplied key detectors, the display shows "1:Detector1".
*10 If you register 2 or more key detectors.
*11 If you subscribe to a Call Display service and want to view the caller's information after lifting up the
handset to answer a call, turn off this feature.
*12 The flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if
necessary.
*13 Generally, the line mode setting should not be changed. This setting automatically maintains receiver
volume at the proper level depending on the current telephone line condition. Set the line mode to
"A" if telephone line condition is not good.

Alarm

An alarm sounds at the set time for 1 minute and
is repeated 5 times at 5 minute intervals (snooze
function). A text memo can also be displayed for
the alarm. A total of 3 separate alarm times can be
programmed for each handset. You can set one of
3 different alarm options (once, daily, or weekly)
for each alarm time.
Important:
R Make sure the unit's date and time setting is
correct (page 13).
Handset
1
MMENUN#720
2
MbN: Select the desired alarm. a MSELECTN
32
TGF3xxC(en)_1216_ver011.pdf 32
*8
Sub-menu 2 Settings
–
–
For assistance, visit www.panasonic.ca/english/support
Code
– #655
–
3
MbN: Select the desired alarm option. a
MSELECTN
"Off" Turns alarm off. Go to step 10.
"Once" An alarm sounds once at the
set time.
"Daily" An alarm sounds daily at the set
time. Go to step 5.
"Weekly" Alarm sounds weekly at the set
time(s).
4
Proceed with the operation according to your
selection in step 3.
n Once:
Enter the desired month and date. a MOKN
2014/12/16
Unit
–
19:11:01