Mode Menu Access - GSE 675 Technical Reference Manual

Model 672/675 Technical Reference Manual
20 [ALPHA]
This method requires fewer keystrokes as only the instance number must be keyed in prior to pressing
[ALPHA].
Variables must be allocated at P680 before they can be accessed.
I I
NVALID NSTANCE
An error message will be displayed whenever an invalid instance is specified. For example, if scale #3 is not
enabled and you key in 0.3 [SELECT] to access the gross weight for scale #3, "Invld Instn" is briefly
displayed indicating that the selection was not valid. The gross mode will be selected. However, the
instance displayed will be the nearest valid instance.
For example, if the counting mode is disabled and you key in 37 [SELECT] to access the last sample size,
FuNt2 will be displayed indicating that the selection was not valid. This is because the counting mode must
be enabled to access 30P → 37P as indicated in Table 7-1. The instance displayed will be the nearest valid
instance, in this case 29P, future net #2.
Displayable parameters 50P → 82P require an instance. Failure to specify one will result in the automatic
selection of the first instance for the selected parameter.
M M A
ODE ENU
A convenient way to access frequently used operating parameters is to assign them to the Mode Menu
parameters at P300 → P309 of the setup mode. This allows you to toggle through up to ten different
operating parameters in the weigh mode using only the [SELECT] key. The first parameter in the Mode
Menu list will be the first parameter displayed at power-up or upon exiting the setup mode.
By default, the gross weight is assigned to P300, the net weight to P301 and the tare weight to P302. Thus,
the Model 672/675 powers-up in the gross mode and pressing [SELECT] toggles the weigh mode to net,
then to tare, and then back to gross.
E M
DITING THE ODE
The following procedure describes how to edit the Mode Menu selections. In this example, the factory
default configuration is altered for an application performing gross weight accumulations. The time/date will
be displayed at power-up. Pressing [SELECT] will toggle through gross, gross total, gross total + current
gross, number of accumulations, then back to time/date.
To edit the Mode Menu selections:
1. Access the setup mode.
2. Key in 300 [SELECT] to access the first menu selection (mode 0).
3. Key in 11 [ENTER] to select the time/date parameter.
4. Press [SELECT] to access the next menu selection at P301 (mode 1).
5. Key in 0.0 [ENTER] to enter the gross parameter for the current scale.
6. Press [SELECT] to access the next menu selection at P302 (mode 2).
7. Key in 3.0 [ENTER] to enter the gross total parameter for the current scale.
8. Press [SELECT] to access the next menu selection at P303 (mode 3).
9. Key in 4.0 [ENTER] to select the gross total + current gross weight parameter for the current scale.
10. Press [SELECT] to access the next menu selection at P304 (mode 4).
11. Key in 9.0 [ENTER] to select the number of accumulations parameter for the current scale.
selects variable #20
CCESS
M S
ENU ELECTIONS
7-5