Installation And Accessory Parts - Haier WD-8888-71 Service Manual

INSTALLATION AND ACCESSORY PARTS

Install the drain hose
•
First install the drain hose hook on the parts of outer drain hose component.
•
Put the drain hose clamp on the outer drain hose, insert the outer drain hose
into the joint for it, and then clutch tightly with drain hose clamp.
Usage of the drain hose
• Hang the outer drain hose at the proper
place before washing (do not use it toppled
down on the ground).
• Attend that the outlet of drain hose shall be
higher than the water level in washtub to
avoid siphon phenomenon.
Install the water inlet hose
1. Insert a new flat washer into each end of the inlet hoses. Firmly seat the washer
in the coupling. (As figure 1)
2. Respectively attach the water inlet hoses to the water faucet. Using pliers,
tighten the coupling. (As figure 2) NOTE: Do not over tighten. Damage to the
valves can result.
3. Run water through the faucets and inlet hoses, into a bucket or laundry tub, to
get rid of particles in the water lines that might clog the inlet valves screens.
4. Attach the hose connected with the water faucet to the water valve. (As figure 3)
NOTE: Do not over tighten. Damage to the valves can result.
9