Maintenance And Troubleshooting - Haier WD-8888-71 Service Manual

MAINTENANCE SERVICE AND TROUBLESHOOTING
Wash test C2: The remain time digitron displays C2. The medium water level, wash
and normal indicator lights are on. After 3 seconds the wash digitron displays 20.
The wash digitron flashes. It will execute wash current, and switch off the power
automatically after 20 minutes. Push the program button to switch. See to the
following table for the current. Switching will influence the time. During this
procedure, only the reserve, program and start/pause buttons are enabled. It will
not detect the top lid opening.
Normal
Quick
Posthaste
Jean
Spin test C3: The remain time digitron displays C3. The spin and normal indicator
lights are on. After 3 seconds the spin digitron displays C5. The spin digitron flashes.
After 5 minutes of spinning, it will switch off the power automatically.
Check the top lid opening and tub bumping during spinning, and test the breakdown
alarm. During this procedure, only the reserve and start/pause buttons are enabled.
In the moment while it just enters spinning procedure, opening of top lid will activate
alarm. Manually create one imbalance situation, and confirm that it activates
imbalance alarm.
3. Troubleshooting charts
If you replace the computer program controller without checking the other
components carefully, the computer program controller may be damaged again.
Therefore, please first check if the other components are working normally before
replacing the computer program controller in maintenance.
1. No action. (The indicator is off)
0.7/0.5
0.8/0.5
1.0/0.5
1.2/0.5
l fiber
Cotton
Woolen
Silk
0.6/0.5
0.4/0.5
0.2/0.5
0.3/0.5
19