Haier WD-8888-71 Service Manual page 10

5. Check for leaks
(1). Swing the water inlet hose gently to confirm if it's suitable.
(2). Turn on the water faucets and check for leaks. A small amount of water might
enter the washers. You will drain this later.
Do not take off the water absorption cushion. Please check if the cushion is dropped
or damaged before each usage. If it happens please contact our after-sale
department immediately.
Please install and adjust the machine according to the requirement of the
service manual, which is very important for safe and proper usage of the
machine.
Install the inner cover component
Please install the inner cover component as per
followings in your first usage of the washing
machine:
1. Open the top lid of the washing machine.
2. Put the inner cover component on the outer
tub cover, aiming the inner cover shaft to the
installation hole of the corresponding outer tub
cover shaft groove.
3. Firstly insert the inner cover shaft of one side
into the corresponding outer tub cover shaft
groove, then push the point marked with * on
the other side, and push the inner cover shaft
into the corresponding outer tub cover shaft
groove. Please install in designated position to
guarantee there are no droppings or abnormal
sound in opening and closing of the inner cover,
and the operation shall be smooth. Do not dismount the inner cover component
after washing.
(As Figure 4)
10