Table of Contents
Advertisement
Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and
configure various parameters. When tampering is detected, event images
will be sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be pre-
determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of the
duration will be uploading by E-mail when tampering is triggered. The
setting range is from 1 to 9999 seconds. Select <Upload during the trigger
active> to make the images keep being upload to E-mail during the trigger
active until tampering stops. Set the Image frequency as the upload frame
rate. The setting range is from 1 frame to 20 frames.
Send HTTP notification
Check this item, select the destination HTTP address, and specify the
parameters for HTTP notifications. When the Tampering Alarm is
triggered, the HTTP notifications can be sent to the specified HTTP server.
For instance, if the custom parameter is set as" action=1&group=2", and
the HTTP server name is" http://192.168.0.1/admin.php", the notification
will be sent to HTTP server as" http://192.168.0.1/admin.php?
action=1&group=2" when alarm is triggered.
File Name
Enter a file name in the blank, ex. image.jpg. The uploaded image's file name
format can be set in this section. Please select the one that meets your
requirements.
Add date/time suffix
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
60
NOTE: Make sure FTP configuration has been completed. Refer
to FTP for further details
NOTE: Make sure SMTP configuration has been completed.
Refer to Mail for further details.
Advertisement
Table of Contents
