Table of Contents
Advertisement
6.3.2.3
IP Filter
The IP Filter setting can be found under this path: System> Security> IP Filter.
Using the IP filter, access to the IP Camera can be restricted by
denying/allowing specific IP addresses.
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP
addresses (IPv4) will be allowed/ denied access to the IP Camera. Select
<Allow> or <Deny> from the drop-down list and click on the <Apply> button to
determine the IP Filter behavior.
Add/ Delete IP Address
Input the IP address and click on the <Add> button to add a new filtered
address. The Filtered IP Addresses list box shows the currently configured IP
addresses. Up to 256 IP address entries may be specified.
To remove an IP address from the list, please select the IP and then
click on the <Delete> button.
32
Advertisement
Table of Contents
