SeaDoo GTI Shop Manual page 658

Section 13 PROPULSION
Subsection 02 (DRIVE SYSTEM)
1. PTO seal support tool
1. Insert in groove of PTO seal assembly
Remove jet pump. Refer to JET PUMP section.
Install drive shaft holder on pump support as
shown.
MODEL
GTX 4-TEC
RXP 4-TEC
NOTE: This is necessary so the drive shaft cannot
move rearwards when using the drive shaft/float-
ing ring tool.
658
TYPICAL
1. Drive shaft holder
Disconnect EGTS sensor to make room.
For the following operations, use the drive
shaft/floating ring tool .
NOTE: Note that there is a large opening and
TOOL P/N a small opening on the tool. Depending on the
step involved in the procedure, it is sometimes
529 035 871
required to reverse its installation position.
529 035 986
www.SeaDooManuals.net
MODEL
GTX 4-TEC
RXP 4-TEC
TOOL P/N
529 035 841
529 035 987
smr2004-Complete Line Up