SeaDoo GTI Shop Manual page 261

TYPICAL — GTX 4-TEC ENGINES
1. O-ring
2. Rubber ring gasket
TYPICAL — RXP 4-TEC ENGINES
1. Gasket
2. Rubber ring gasket
If rubber rings are brittle, cracked or hard, replace
them.
Clean both contact surfaces of oil strainer cover.
Check and clean the oil inlet and outlet area for dirt
and other contaminations.
smr2004-Complete Line Up
Subsection 06 (LUBRICATION SYSTEM)
TYPICAL
1. Oil inlet to the oil pump
Installation
For installation, reverse the removal procedure.
Position screws according to their length as
shown.
TYPICAL
1. Screws M6 x 25
2. Screws M6 x 85
Torque suction pump cover screws to 10 N•m
(89 lbf•in) as per sequence illustrated below. Ap-
ply Loctite 243 on threads.
www.SeaDooManuals.net
Section 05 ENGINE (4-TEC)
243