SeaDoo GTI Shop Manual page 228

4-TEC SUPERCHARGED ENGINES
1. Cable position in bracket
2. Cable barrel position in cam
Supercharger
4-TEC Supercharged Engines
Sealing surface between supercharger and PTO
housing has to be greased with Super Lube grease
(P/N 293 550 030).
1. Super Lube grease
Install supercharger ass'y on PTO housing. Apply
Loctite 243 (blue) on the retaining screws.
Torque screws to 10 N•m (89 lbf•in).
To tighten and torque the upper screw, use the
Torx adapter (P/N 529 035 938).
smr2004-Complete Line Up
Ensure to install the tool perpendicularly (90°) to
torque wrench to apply the proper torque to the
screw.
1. Tool perpendicular (90°) to torque wrench
A. 90°
CAUTION: Not installing the tool as shown will
change the torque applied to the screw. Proper
torque and tightening sequence are important.
After complete installation of the supercharger
ass'y the slipping moment has to be rechecked.
Refer to SLIPPING MOMENT INSPECTION above
in this section.
Finalizing the Installation
Readjust throttle cable and reset the TPS using the
VCK. Refer to ENGINE MANAGEMENT section.
When reinstalling exhaust system components,
validate LH muffler/exhaust pipe alignment with
exhaust manifold. Refer to EXHAUST SYSTEM.
www.SeaDooManuals.net
Section 05 ENGINE (4-TEC)
Subsection 02 (INTAKE SYSTEM)
207