Proaction VC9340S-6 Instruction Manual page 5

ASSEMBLY
Using the Attachments
1. Place vacuum cleaner in its upright
position. Make sure that the
vacuum cleaner is NOT plugged
into the mains when adding or
removing accessories.
2. Turn the Carpet Height Adjustment
Knob G to the highest position.
See fig. 5.
3. Remove the hose connector from
the rear of the unit and push in the
desired attachment firmly onto the
end of the hose.
See fig. 6.
4. If additional length is required,
attach one or both of the Extension
Tubes S to the end of the hose
and then attach the Air-driven
Turbo Brush C , Crevice Tool E
or Upholstery Brush T to the end
of the Extension Tube S .
See fig. 7 and 8.
NOTE: Please note that there are
two Extension Tubes S in the
unit. You need to use some force
to separate the Tubes.
See fig. 7 and 8.
6
G
fig. 5
G
Hose Connector
E
fig. 6
ASSEMBLY
WARNING: Avoid tipping the
vacuum cleaner or standing it
on furniture, fringed rugs or
carpeted stairs, whilst you are
using the hose with the
attachments. When the vacuum
cleaner is turned on, the beater
brush will continue to rotate.
Avoid leaving the vacuum
cleaner in one place for an
extended period of time,
particularly on thick carpet.
CAUTION: Do NOT pull the vacuum
cleaner around the room by the
hose as it could tip over and
cause damage. Do NOT over
stretch the hose. Trying to reach
beyond the hose's extended
length could cause the vacuum
cleaner to tip over.
E
U
T
C
C
fig. 7
S
T
U
S
Hose Connector
fig. 8
S
7