Replacing The Drive Belt; Cleaning The U Tube - Proaction VC9340S-6 Instruction Manual

REPLACING THE DRIVE BELT

Cleaning & Changing the Belt
1. Should the Drive Belt become
worn or slips you can replace with
the spare Drive Belt V included
with the accessories.
2. Unplug the Cleaner from the mains.
3. Release the Handle by pressing
the Handle Release Pedal Q .
Carefully turn the unit over and
remove the four fixing screws.
Ensure you keep all the screws in
a safe place.
See fig. 30.
4. With the unit still lying down, turn
it around and lift the adjust knob.
5. Lift the cover of the power head
starting from the back of the power
head.
6. Remove the Roller Brush lifting it
firmly upwards to release it.
See fig. 31.
7. Replace the worn out Dive Belt
with the new Drive Belt V .
Carefully stretch the new belt over
the Roller Brush and ensure it is
well fitted at the roller ends.
See fig. 31.
8. Refit the Cover in the same way
using the four fixing screws.
NOTE: Only use the Drive Belt
supplied. Using another belt
could create a hazard and
would invalidate the warranty.
18
Base View
fig. 30
Roller Brush
V
fig. 31

CLEANING THE U TUBE

Unblocking The "U" Tube
1. If rubbish is blocked inside the
"U" tube, open the U Tube Cover
P and remove blockage then
close the cover.
See fig. 32.
Fixing
Screws
WARNING : The cover must be
closed whilst vacuuming,
otherwise it will not pickup.
P
fig. 32
19