Download Print this page

Electrical Connection; Removal; Transporting; Protection Against Frost (Emptying The Appliance) - Bosch SM Series Instruction Manual

Hide thumbs

Advertisement

Electrical connection

Connect the appliance to an
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See
rating plate for required fusing 92.
The socket must be near the
appliance and freely accessible
following installation.
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side to
satisfy the relevant safety
instructions.
The connection may be modified
by technicians only.
A power cord extension may be
purchased from customer service
only.
Use only a residual current operated
circuit-breaker which features the
symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
damage protection system. Please
note the system will function only
when the power supply
is connected.

Removal

Also observe
the sequence of worksteps here.
Disconnect the appliance from the
1.
power supply.
Turn off the tap.
2.
Undo the waste water and drinking
3.
water connection.
Loosen fastening screws for the
4.
furniture parts.
If fitted, remove the base panel.
5.
Pull out the appliance, carefully
6.
pulling the hose behind.
Installation and connection aus

Transporting

Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
Turn on the tap.
1.
Open the door.
2.
Switch on ON/OFF switch (.
3.
Select programme with the highest
4.
temperature.
The estimated programme duration
is indicated on the display window at
the top @.
Press START button h.
5.
Close the door.
6.
Programme sequence starts.
Open the door after
7.
approx. 4 minutes.
Press START button h until
8.
"Program was terminated"/"Ready in
one minute." is indicated at the top
of the display window @.
Close the door.
9.
Open the door after approx. 1
10.
minute.
The display window at the top @
indicates; "Finished".
Switch off ON/OFF switch (.
11.
Turn off the tap, disconnect supply
12.
hose and drain water.
Transport appliance upright only.
Note:
This prevents residual water from
running into the machine control
and damaging the programme
sequence.
Protection against frost
If the appliance is in a room where there
n g t h e a p p l i a n c e )
s t f r o s t ( E m p t y i
P r o t e c t i o n a g a i n
is a risk of frost (e.g. holiday home),
empty the appliance completely (see
Transportation).
47

Advertisement

loading

  Also See for Bosch SM Series

This manual is also suitable for:

Sb series