Fault Table - Bosch SM Series Instruction Manual

aus Fault, what to do?

Fault table

Fault
Error code ":‹ˆ is lit.
Error code ":‚ƒ is lit.
Error code ":‚‰ is lit.
Error code ":ƒƒ is lit.
Error code ":ƒ... is lit.
Error code ":Ġ is lit.
Error code ":ƒˆ is lit.
36
Cause
Intake opening (on right inside of
appliance) covered by utensils.
Heating element calcified or
soiled.
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out the
Filters 1R are soiled or
blocked.
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Mains voltage too low.
Remedial action
Arrange utensils so that the intake
opening is not obstructed.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting.
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min. when
water supply is open.
mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Clean filters. ~ "Filters" on page 33
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly. ~ "Waste water
pump" on page 35
Clean pump and lock cover correctly.
~ "Waste water pump" on page 35
Not an appliance fault, have the mains
voltage and electrical installation checked.