Change, Rem-M&C, Configure Menu - Paradise Datacom P300-VSAT Installation & Operating Handbook

6.9.2 Change, Rem-M&C, CONFIGURE Menu
This menu configures the remote M&C port: The options are:
PROTOCOL
INTERFACE
BAUD RATE
ADDRESS
P300H
Remote M&C: 1:Protocol [Paradise]
2:Intfc [RS485] 3:Baud rate[2400] 4:Addr[123]
Change, Rem-M&C, Configure Menu
This allows selection between OFF, PARADISE/FDC, and SA-bus. Full details of
the remote M&C protocols and messages is provided in the Remote M&C section
in Appendix D.
NOTE: Remote monitoring is possible with the selected protocol if the protocol
is not set to OFF. Remote control is only possible if the protocol is not Off and
control has been selected as Remote on the Change, Remote M&C menu.
The options available here are RS232 or RS485. RS232 is only usable for a
direct connection between a single device and a PC. RS485 is required when
more than one slave device is connected to the remote M&C bus. Again see the
Remote M&C section for complete details of the electrical interface.
The remote M&C Baud Rate is selectable, again see the Remote M&C section
for complete details of suitable Baud Rates for each protocol.
The bus address must be specified. The valid range for the Paradise / FDC
protocol is 1-255, for the SA-bus protocol the valid range of address is 49 to 111
(31H to 6FH).
P300 Modem Installation and Operating Handbook Page 98