Partial Insert And Multidestinational Working - Paradise Datacom P300-VSAT Installation & Operating Handbook

8.3

PARTIAL INSERT AND MULTIDESTINATIONAL WORKING

Partial Insert is only available if the Extended D/I feature is available (standard on P300-TCM). In a typical
scenario, there may be a 2048kbps incoming carrier, containing say 8 timeslots (512kbps) for this
destination. When set to All the full 2048kbps has to be received and passed to the terrestrial. When set
to Partial, only the 8 timeslots for this destination are selected and inserted onto the insert mux bearer
avoiding overwriting all the data on the bearer.
This technique can be applied to lower rate carriers also. Imagine four destinations which require mesh
connectivity for simplicity say at 384kbps (6 x 64kbps, although asymmetric operation up to any rate is
possible). Each site has a modulator transmitting 1152kbps (3 x 384kbps), and three demodulators
receiving the 384kbps from the other sites. The satellite bandwidth requirement is for four 1152kbps
carriers, not twelve 384kbps carriers (ie the same aggregate rate, but possibly lower overall bandwidth
when carrier spacing is taken into consideration):
A single T1 or E1 bearer is looped through three modems, one operating as Tx/Rx, and two others
in Rx only. In this example we will assume it is a T1 PCM bearer.
The Tx data for all destinations arrives at the single Tx modem in each site on the T1 bearer in 18
timeslots. Note that the ability to re-order the Tx & Rx timeslots means the data can be in any
timeslots and in any order.
Each of the four sites transmits a 1152kbps (3 x 384kbps carrier) and all four destination sites
receive the three carriers from the other destinations.
At each site all three modems are configured for Rx Partial Insert, and the data for all but this site
is discarded leaving a 384kbps to be inserted onto the looped T1 bearer by each Rx modem. In
this way the data from each site for this destination can be re-inserted into the original timeslot
from which the Tx data was dropped.
Without Partial Insert if each Rx modem inserts all the received data (18 timeslots) onto the T1 bearer,
then the second Rx modem could just about insert its 18 timeslots without stamping on the 6 timeslots for
this destination from the first Rx modem. However Rx modem 3, still has 18 timeslots to insert, but 12 of
the timeslots on the T1 bearer now contain receive information from Rx modems 1 & 2, and so Rx modem
3 cannot insert all its data without losing data from another destination. The traditional alternative without
Partial Insert is to use separate bearers for each Rx modem and a DACCS to sort our the data, but it's
lower cost and less equipment to configure and maintain if the DACCS is not required at all !
Partial Insert becomes mandatory for multidestinational working when the total receive data at any one
destination exceeds the capacity of the PCM bearers.
One final note: The P300 can provide multidestinational operation at aggregate carrier rates below 1544
kbps using the IBS overhead, but with four backward alarms. So multidestinational working down to
64kbps between nodes become practical (ie you don't have to use the 96kbps IDR overhead on the links
to get multidestinational backward alarm facilities).
P300H P300 Modem Installation and Operating Handbook Page 133