Installation - Alpine HDA-5460 Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
1
Bracket
Mounting Sleeve
(Included)
Slide mounting sleeve from main unit (see
Removal Procedure below). Slide the mounting
sleeve into the dashboard.
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Chassis
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the HDA-5460 and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
Metal plate
Detachable
Front panel
Dashboard
Rubber Cap
(Included)
Hex Bolt
(Included)
This unit
Screw
2
*
Bolt Stud
1
*
This unit
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*
attached to the vehicle's chassis. Connect all the
leads of the HDA-5460 according to details
described in the BASIC CONNECTIONS section.
2
• For the screw marked "* ", use an appropriate screw for the
chosen mounting location.
3
Lock Pin
Slide the HDA-5460 into the dashboard. When the
unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the detachable front panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
HDA-5460
* 3
Ground Lead
Mounting Bracket
• Secure the ground lead of the unit to a clean metal spot using a
screw (* 3 ) already attached to the vehicle's chassis.
1 ) already
Face Plate
Screws (M5 × 8)
(Included)
Head unit (Ai-NET)
17
-EN