Table of Contents
Advertisement
IMPORTANT NOTE
In the event that these conditions can not be met (for certain configurations or co-location with another transmitter),
then Industry Canada certification is no longer considered valid and the IC Certification Number can not be used on
the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate Industry Canada authorization.
End Product Labeling
The BLE113 Module is labeled with its own IC Certification Number. If the IC Certification Number is not visible when
the module is installed inside another device, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module. In that case, the final end product must be labeled in a visible
area with the following:
"Contains Transmitter Module IC 5123A-BGTBLE113" or "Contains IC 5123A-BGTBLE113"
The OEM of the BLE113 Module must only use the approved antenna(s) listed above, which have been certified with
this module. The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user's manual of the end product.
The user's manual for the end product must include the following information in a prominent location:
"To comply with Industry Canada RF radiation exposure limits for general population, the antenna(s) used for
this transmitter must be installed such that a minimum separation distance of 20cm is maintained between the
radiator (antenna) and all persons at all times and must not be co-located or operating in conjunction with any
other antenna or transmitter."
Radio Equipment - Canadian Warning Statements
"Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication." "This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device."
"Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peutfonctionner avec une
antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne
et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante.""Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement."
"To comply with industry Canada RF radiation exposure limits for general population, the antenna(s) used for this
transmitter must be installed such that a minimum separation distance of 20cm is maintained between the radiator
(antenna) and all persons at all times and must not be co-located or operating in conjunction with any other antenna
or transmitter."
37
Advertisement
Table of Contents
