Enabling Bluetooth (Bt) Connection - be bionic steeper Technical Manual

5.5 Enabling Bluetooth (BT) Connection

Selecting the bebionic Hand tab in the top left
hand corner of the entry screen will open the main
selection screen.
Enabling bluetooth module on the bebionic
small hand.
Ensure the BT dongle is inserted into a USB port
of the computer before continuing. With the hand
switched ON enable the BT module on the hand by
pressing and holding the button on the back of the
hand for approximately six seconds, or until you hear
a double beep/vibrate indication.
Note: This function differs from the glove donning
mode. To enable the BT communication the hand
must be switched ON, whereas in glove donning
mode the hand must be switched OFF. The BT
communication can be disabled by pressing the
button on the back of the hand for longer than two
seconds. Alternatively, you can disconnect the power
to the hand by using the battery switch.
Click on the Bluetooth button in the top right hand
corner of the screen (highlighted above).
Doing this will open the dialog box shown above.
Click on Device Scan (highlighted above). The system
will automatically start to scan for bebionic devices.
Select your device and press the middle right hand
button Connect (highlighted above). The dialog box
will automatically close once the connection is made.
Once connected you should notice a green connection
box on your main selection screen (highlighted above).
25