Troubleshooting; Care And Maintenance; Cleaning Your Refrigerator - Summit SCR 1300 Instruction Manual

Before calling a repairman, check that:
● The plug is properly connected into the wall socket.
● The fuse (or circuit breaker) is intact.
● The power has not been cut off.
● All controls are correctly set.
● Switch off the cabinet for 15 minutes (by setting the thermostat to 0). Switch it on
again and after 5 minutes, check whether frost has formed on the evaporator.
● Do not open the cabinet unnecessarily.

CLEANING YOUR REFRIGERATOR

● Turn off the power, unplug the appliance, and remove all items, including shelves.
● Wash the inside surfaces with a solution of warm water and baking soda (about 2 table-
spoons of baking soda to a quart of water).
● You may remove the top panel and wash it when cleaning inside the cabinet.
● Wash the shelves with a mild detergent solution.
● Wring excess water out of the sponge or cloth when cleaning the area where the controls
are located, or any electrical parts.
● Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe
dry with a clean soft cloth.
● The kick panel can be removed to facilitate vacuum cleaning the floor.
● Do not use steel wool or a steel brush on the stainless steel.
● To make the cooling system work at its best, it is necessary from time to time to clean the
wire condenser and the compressor at the back of the cabinet with a brush or vacuum
cleaner. Remember to clean the drain.

TROUBLESHOOTING

CARE AND MAINTENANCE

12