Normal Function; Auto Image Function - Ask Proxima 9280 User Manual

The normal picture level is preset on this projector at the
factory and can be restored anytime you press the NORMAL
button (located on the Top Control or on the Remote Control
Unit). The "Standard" display will be displayed on the screen
for a few seconds.
The Auto Image function is provided to automatically adjust Fine sync., Total dots, and Picture Position for most
computers.
Press the MENU button and the ON-SCREEN MENU will
1
appear. Press the POINT LEFT/RIGHT buttons to select AUTO
IMAGE and press the SELECT button.
Another dialog box AUTO IMAGE Menu will appear.
Move the arrow to an item that you want to adjust by pressing
2
the POINT UP/DOWN button. Change the setting On or Off by
pressing the SELECT button.
Fine sync
Adjust the picture as necessary to eliminate flicker from the display.
This item can be adjusted manually. (Refer to page 28.)
Total dots
The number of the total dots in one horizontal period. This item can
be adjusted manually. (Refer to page 28.)
Position
Adjustment of the position of the image. This item can be adjusted
manually. (Refer to page 30.)
3 Move the arrow to "Go!" and press the SELECT button to start
the Auto Image function.
This adjustment can be executed by pressing AUTO IMAGE
button on the Top Control or on the Remote Control Unit.
Stored
Stores the On/Off setting of each item.
Go! Starts the Auto Image Adjustment.
Quit Closes the AUTO IMAGE ADJUSTMENT Menu.
NOTE : This menu cannot be operated when the input signal is from the COMPUTER INPUT-1 (DIGITAL) terminal or
"RGB," "HDTV720p," "HDTV1035i" or "HDTV1080i" is selected on the SYSTEM MENU (P24 and 25).
The Fine sync., Total dots, and Picture Position of some computers may not be fully adjusted with the Auto Image
Function. In that case, manual adjustment is required to make fine image. (Refer to page 28 to adjust "Fine sync."
or "Total dots" and page 30 to adjust Picture Position.)

NORMAL FUNCTION

AUTO IMAGE ADJUSTMENT
COMPUTER MODE
Standard
Starts the adjustment
on the item set to "On".
Terminates the AUTO IMAGE
ADJUSTMENT Menu.
Move the arrow to
the item and then
press the SELECT
button.
29