Advertisement
The playback mode (SP or LP) is selected automatically according to the format in which the tape has
been recorded. The quality of the recorded picture in LP mode, however, will not be as good as that in
play) mode
When you play back a tape recorded in LP mode, the LP indicator lights up on the LCD screen or in the'
viewfinder. This camcorder cannot record a tape in LP mode.
Foreign 8 mm video
You cannot play back software recorded on a different TV color system. Because the TV color systems
differ from country to country, you may not be able to play back foreign pre-recorded software. Refer
to page 39 to check the TV color system of fore@ countries.
This section shows you how you can get the most out of your battery pack.
Always Carry Additional Batteries
Have sufficient battery pack power to do 2 to 3 times as much recording as you have planned.
Battery Life is Shorter in Cold Environment
Battery efficiency is decreased and the battery will be used up more quickly if you are recording in a
cold environment.
To Save Battery Power
A smooth transition between scenes can be made even if recording is stopped and started again. While
you are positioning the subject, selecting an angle, looking through the viewfinder lens or at the LCD
screen, the lens moves automatically and the battery is used. The battery is also used when a tape is
inserted or removed.
While you are using your camcorder, the remaining battery indicator in the viewfinder or on the LCD
screen decreases gradually as battery power is used up.
When the remaining battery indicator reaches the lowest point, the 47 indicator appears and starts
flashing in the viewfinder or on the LCD screen. [al
When the GI indicator in the viewfinder changes from slow flashing to rapid flashing while you are
recording, slide the POWER switch to OFF on the camcorder and replace the battery pack. Leave the
tape in the camcorder to obtain a smooth transition between scenes after the battery pack is replaced.
remaining battery indicator
Note on the
The
remaining battery indicator of the camcorder may indicate a different remaining capacity from
that of a battery pack with its own indicator (not supplied). The indicator on the battery pack is more
accurate.
The Battery Pack Heats Up
During charging or recording, the battery pack heats up. This is caused by energy that has been
generated and a chemical change that has occurred inside the battery pack. Thii is not cause for
concern.
Battery Pack Care
Remove the battery pack from the camcorder after using the battery pack, and keep it in a cool place.
l
When the battery pack is attached to the camcorder, a small amount of current flows to the
camcorder even if the POWER switch is set to OFF, which shortens battery life.
The battery pack is always discharging even when it is not in use after charging. Therefore, you
l
should charge the battery pack right before using
How to Use the Switch on the Battery Pack
This switch is provided so that you can mark the charged battery pack. Set the switch to the "no mark"
position when charging is completed. Set the switch to the "red mark" position when the battery is
used up (or in whichever direction you want to remind yourself). [bl
The Life of the Battery Pack
If the battery indicator flashes rapidly just after turning on the camcorder with a fully charged battery
pack, the battery pack should be replaced with a new fully charged one.
Charging Temperature
You
should charge batteries at temperatures from 50°F to 86°F (from 10°C to 30°C). Lower
temperatures require a longer charging time.
the
camcorder.
Advertisement
