Advertisement
7-1.
CAMERA SECTION ADJUSTMENTS
l-1. PREPARATIONS BEFORE ADJUSTMENT
(CAMERA SECTION)
l-1 -2. Preparations 4
Page. 7-2
Note 1: For further details of how to remove the cabinet and
each board, refer to "2. Disassembly".
Note 2: When adjusting only, the lens block and VC-151 board
need not be taken apart.
Connect the equipments for adjusting as shown in Fig.
7-l-3.
If remove the cabinet (R) (Power switch, camera function
switch, LCD unit and electronic view-finder), set to the
camera power supply ON mode (Note l), and disconnect the
following connectors.
1. CN503 of VS-119 board
2. CN206 of VS-119 board
3. CNlOl of ZB-2 board
4. CN902 of DD-71 board
Be sure to exit this mode after completing the adjustment.
(Note 2)
Turning OFF the Auto Focus Using the Adjusting Remote
3)
Commander
Set data: 01 to page: 6, address: 25.
1.
(The auto focus will turn OFF. The focus can be
adjusted using the focus button on the adjusting remote
commander. But the HOLD switch must be set to
OFF.)
2. After completing the adjustment/operation check, set
data: 00 to page: 6, address: 25.
Setting the Forced Camera Power Supply ON Mode
Note 1:
1) Set data: 01 to page: 1, address: 00.
2) Set data: 21 to page: D, address: 03, and press the
PAUSE button of the adjusting remote commander.
By carrying out the above, the camera can be operated
even if the cabinet (R) has been removed. Be sure to
exit the forced camera power ON mode after
completing the adjustment.
Note 2:
Exiting the Forced Camera Power Supply ON Mode
1) Set data: 01 to page: 1, address: 00.
2) Set data: 00 to page: D, address: 03, and press the
PAUSE button of the adjusting remote commander.
3) Set data: CO to page: 1, address: 00.
SECTION 7
ADJUSTMENTS
Pattern box
Front side of the lens
Fig. 7-1-2.
7-l
Advertisement
