Makita LS1020 Instruction Manual page 3

17.
USE RECOMMENDED ACCESSORIES.
Consult the owner's manual for
recommended accessories. The use of improper accessories may cause risk
of injury t o persons.
18. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or
if the cutting tool is accidentally contacted.
19.
CHECK DAMAGED PARTS.
Before further use of the tool, a guard or other
part that is damaged should be carefully checked t o determine that it will
operate properly and perform its intended function - check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced.
20. DIRECTION OF FEED.
Feed work into a blade or cutter against the direction
of rotation of the blade or cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Don't
leave tool until it comes t o a complete stop.
22.
When servicing use only identical replacement parts.
VOLTAGE WARNING:
Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified o n the
nameplate
of
the tool.
A
power source w i t h voltage greater than that specified
for the tool can result in
SERIOUS INJURY
t o the user - as well as damage t o
the tool. If in doubt,
DO NOT PLUG IN THE TOOL.
Using a power source w i t h
voltage less than the nameplate rating is harmful t o the motor.
3