Table of Contents
Advertisement
When installing two outside cutters
without any inside cutter, be sure that
the cutter tips do not face each other.
0
X
@
While tightening the hex nut, be careful to maintain the even spacing between the tips
of the inside cutters.
@
When cutting 1/2" or narrower grooves, use the table insert originally installed on the
table saw. When cutting 9/16" or wider, use optional accessory table insert (Part No.
343396-9).
Be
sure to install proper table insert.
@
Rotate the dado head one turn by hand to make sure that it does not contact anything
before operation.
When dadoing, use featherboards. The
diagram shown illustrates dimensions for
making a typical featherbord. It should be
made from a straight piece of wood that i s
free of knots or craks.
Kerf should be
2 7
Hide quick links:
Advertisement
Table of Contents
