Bevel Cutting; Adjusting Stopper Plate - Makita ARBOR 2711 Instruction Manual

Bevel cutting
Loosen the lock lever clockwise, then tilt
the blade by swinging the knob until
it
reaches the desired angle ( 0 to
45
degrees).
The bevel
is
indicated on the scale by
the pointer (B). After obtaining the desired
angle, tighten the lock lever counterclock-
wise to secure the adjustment.
CAUTION :
After adjusting the bevel, be sure to tighten the lock lever securely.
Adjusting stopper plate
Secure the lock lever a t the position where
the lock lever contacts the stopper plate.
Make sure the blade is
a t
90 degrees or 45
degrees to the table surface. I f the bevel
is not a t
90 degrees or 45 degrees, proceed
as follows:
:I,
Use the hex wrench to loosen the bolt
securing the stopper plate.
Z
Loosen the lock lever and adjust the
blade to 90 degrees or 45 degrees, then
secure the lock lever.
3
Slide the stopper plate until it contacts
the lock lever, then tighten the bolt
securely.
@ Make sure the pointer (B) points to the 0" or 45" graduation on the bevel scale when
the blade i s a t 90 degrees or 45 degrees. I f
it
does not point to the 0" or 45" gradua-
t i o ! , loosen the screws holding the pointer (B) and align the pointer
(B)
with the
0"
or
45 graduation. Then tighten screws. (Note: The screws holding the pointer
(B)
are
located inside the base.)
1s