Installing And Adjusting Rip Fence - Makita ARBOR 2711 Instruction Manual

255 mm (10") table saw with electric brake
Hide thumbs Also See for ARBOR 2711:
Table of Contents

Advertisement

Installing and adjusting rip fence
Loosen the lever on the rip fence and f i t
the rip fence on the ruler guides.
To check to be sure that the rip fence is
parallel with the blade, secure the rip fence
2
-
3
mm
(5/64"
-
1/8") from the blade.
Raise the blade up to maximum elevation.
Mark one of the blade teeth with a crayon.
Measure the distance (A) and (B) between
the rip fence and blade. Take both measure-
ments using the tooth marked with the
crayon. These
two
measurements should
be identical. I f the rip fence i s not parallel
with the blade, proceed as follows:
Insert a screwdriver into the hole in the
rear end of the rip fence, then loosen
the screw counterclockwise two or three
turns.
Loosen the
two
bolts on the top of the
rip fence with the wrench.
Adjust the rip fence until it becomes
parallel with the blade, then secure it by
tightening the bolts.
Tighten the screw in the hole in the rear
end of the rip fence clockwise two or
three turns.
Lever
Rip fence
Ruler
guide
1
I
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents