Advertisement
Available languages
Available languages
2.
Create
a service
loop with
the copper
tubing.
Avoid
kinks
when coiling
the copper
tubing.
Secure
copper
tubing
to
refrigerator
cabinet
with
a "P" clamp.
A
_
C
9
.........D
c
D
A. "P" clamp
B. Plastic water line
C. Compression
nut
D. Copper
tubing
6.
Check
connection
by pulling
on copper
tubing.
Attach
the
plastic
water
line to the refrigerator
cabinet
with
a "P"
clamp.
7.
Turn on water
supply
to the refrigerator
and check
for leaks.
Correct
any leaks.
Complete
the Installation
A. Copper
tubing
B. "P" clamp
C. Compression
nut
D. Compression
s/eeve
3. Turn on water supply to refrigerator
and check for leaks.
Correct any leaks.
Style 2
1. Create a service loop (minimum diameter of 2 ft [61 cm])
with the copper tubing. Avoid kinks when coiling the copper
tubing.
2. Remove the plastic cap from water valve inlet port. Place a
compression nut and sleeve on the copper tubing.
3.
Insert the end of the copper tubing into the water valve inlet
port. Shape tubing slightly so that the tubing feeds straight
into the port to avoid kinks.
4. Slide the compression nut over the sleeve and screw into the
water valve inlet port.
.
t
......
A
_JC
A. Plastic
water
C. Compression
nut
tubing
D. Copper
tubing
B. Sleeve
Using an adjustable
wrench, hold the nut on the plastic
water line to keep it from moving. Then, with a second
wrench turn the compression nut on the copper tubing
counterclockwise
to completely
tighten. Do not overtighten.
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
1. Plug into a grounded 3 prong outlet.
NOTE. Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to
completely
fill the ice storage bin.
All graphics referenced in the following
instructions are included
later in this section after "Final Steps."
TOOLS NEEDED: _6", %", 1/4" hex head socket wrenches, 3/32"
or 1/8" hex key, #2 Phillips screwdriver, and a flat-blade
screwdriver.
Remove and Replace Handles
1. Using
a
3//32" o r 1/8" hex key, loosen the two setscrews located
on the side of each handle. See graphics 1 and 2.
2. Pull the handle straight out from the door. Make sure you
keep the screws for reattaching
the handles.
3. To replace the handles, reverse the directions.
Advertisement
