Temperature
is too warm
New installation?
Allow 24 hours following
installation
for
the refrigerator
to cool completely.
Door(s) opened often or left open? Allows warm air to enter
refrigerator.
Minimize door openings and keep doors fully
closed.
Large load of food added? Allow several hours for
refrigerator
to return to normal temperature.
Controls set correctly for the surrounding conditions? Adjust
the controls a setting colder. Check temperature
in 24 hours.
See "Using the Control(s)."
There is interior moisture buildup
NOTE" Some moisture buildup is normal.
•
Humid room? Contributes to moisture buildup.
•
Door(s) opened often or left open? Allows humid air to enter
refrigerator.
Minimize door openings and keep doors fully
closed.
ce
Wae "
The ice maker is not producing ice or not enough ice
•
Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
Kink in the water source line? A kink in the line can reduce
water flow. Straighten
the water source line.
Ice maker turned on? Make sure wire shutoff arm or switch
(depending
on model) is in the ON position.
New installation?
Wait 24 hours after ice maker installation
for ice production
to begin. Wait 72 hours for full ice
production.
Freezer door closed completely? Firmly close the freezer
compartment
door. If the freezer compartment
door will not
close all the way, see "The doors will not close completely,"
earlier in this section.
Large amount of ice recently removed? Allow 24 hours for
ice maker to produce more ice.
Ice cube jammed in the ice maker ejector arm?
Remove ice from the ejector arm with a plastic utensil.
Water
filter installed on the refrigerator?
Remove filter and
operate ice maker. If ice volume improves, then the filter
may be clogged or incorrectly
installed. Replace filter or
reinstall it correctly.
Reverse osmosis water filtration system connected to your
cold water supply? This can decrease water pressure. See
"Water
Supply Requirements."