Advertisement
Available languages
Available languages
IMPORTANT."
Your refrigerator
has two adjustable, front leveling screws -
one on each side of the refrigerator
base. If your
refrigerator
seems unsteady or you want the door to close
easier, use the instructions below.
Before moving the refrigerator,
raise the leveling screws so
the front rollers are touching the floor.
Remove the two screws fastening the base grille to the
cabinet, and set the screws aside. Grasp the grille and pull it
toward you.
L
2.
Raise or lower
the cabinet.
Using a 1/4" hex driver,
turn the leveling
screw
on each side
to raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator
takes some weight off the leveling screws. This
makes it easier to turn the screws. It may take several turns
of the leveling screw to adjust the tilt of the refrigerator.
•
To raise, turn the leveling
screw
clockwise.
•
To lower, turn the leveling
screw counterclockwise.
A. Leve/ingf
screw
B. Front
ro//er
.
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator
slightly more to the rear
by turning both leveling screws clockwise. It may take
several more turns, and you should turn both screws the
same amount.
4.
Replace
the base grille.
...... y,.......... /S_-ep{x_8
e_s
Please read before using the water system.
IMPORTANT." After connecting the refrigerator
to a water source
or replacing the water filter, follow the steps below to make sure
that the water system is properly cleaned. This will flush air from
the filter and water dispensing system, and prepare the water
filter for use.
1. Turn off the ice maker by opening the freezer door and
lifting up the wire shutoff arm as shown.
2.
Install the interior water filter. The interior water filter
mounting bracket is located on the left side wall of the
refrigerator
compartment.
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Remove blue bypass cap and retain for later use.
Gently remove the interior water filter from its
packaging.
Remove the sealing label from the end of the
filter and insert it into the filter head.
Gently rotate the filter clockwise until it stops. Then snap
the filter cover closed.
.
Press the Water
button on the dispenser control panel. Use a
sturdy container to depress and hold the dispenser lever for
5 seconds, then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser lever (5 seconds on,
5 seconds off) until a total of 4 gal. (15 L) has been
dispensed. This will flush air from the filter and water
dispensing system, and prepare the water filter for use.
Additional
flushing may be required in some households. As
air is cleared from the system, water may spurt out of the
dispenser.
NOTE: After 5 minutes of continuous dispensing, the
dispenser will stop dispensing water to avoid flooding.
To
continue dispensing, remove the container and press the
dispensing lever again.
11
Advertisement
