Sideburner - Kenmore 146.34611410 Use & Care Manual

Sideburner
[] Loosen side burner in side shelf. (B). To loosen, unscrew and remove two front screws and washers
holding sideburner in place. (A). Note: Do not loosen electrode screw.
[] Remove the 2 pre-insfalled screws from the valve stem and set them aside. (C)
[] Insert valve stem through hole in fascia. (D) Attach bezel to fascia and valve face with previously
removed 2 screws. Attach bezel with black mark facing up (E).
[] Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (F)
[] Push control knob onto sideburner valve stem. (G)
[] Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
grate. (H)
[] Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.(I)
[] Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)
24 "34611-40100219