Intercom Failure; Intercom Reconnection; S Configuration Setting - Sena BS User Manual

Bluetooth headset & intercom for scooters and motorcycles
Table of Contents

Advertisement

intercom call. You will also hear a voice prompt saying "Intercom
requested". In this case, the intercom call does not override the
mobile phone call because intercom has lower priority than mobile
call. You have to hang up the mobile phone call to make or receive an
intercom call.

Intercom Failure

When you try to start an intercom conversation with an intercom friend
who is already having a mobile phone call with another person, you will
hear a low tone double beep signifying a busy signal. You will also hear a
voice prompt saying "Intercom failed, try again later". In this case, you
have to try again later. On the other hand, the intercom friend will hear
4 high tone beeps alerting them that there is an incoming intercom call.

Intercom Reconnection

If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom will
be disconnected. In this case, the 3S automatically tries to reconnect
the intercom every 8 seconds. You will hear high tone double beeps until
the intercom is reestablished. If you don't want to make a reconnection,
press and hold the (-) Button for 1 second to stop the attempt.

7. 3S CONFIGURATION SETTING

You can set the configuration of the 3S by the voice menu instruction as
below.
1. To enter into voice configuration menu, press and hold the (+) Button
for 10 seconds until the LED shows solid blue and you hear high tone
double beeps. You will hear a voice prompt saying "Configuration
menu".
2. Press the (+) Button to navigate between menus. You will hear voice
prompts for each menu items as below.
3. You can enable or disable the feature or execute the command by
pressing the (-) Button.
4. If any button is not pressed within 10 seconds, the 3S will exit the
configuration and goes back to standby.
5. If you want to exit the configuration immediately, press and hold the
(+) Button until you hear a voice prompt, "Exit configuration", and
press the (-) Button.
3S
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

3s

Table of Contents