Adjusting The Miter Gauge; Adjusting The Cutting Height - Craftsman 320.37599 Operator's Manual

ADJUSTING THE MITER
GAUGE (Fig. 21)
_, WARNING: Failure to unplug
your router before performing
adjustments to the router or table
could result in accidental starting
causing serious injury.
1 Loosen the miter gauge knob.
2. Rotate the miter gauge to the
desired angle.
3. Tighten the miter gauge knob.
Fig. 21
ADJUSTING THE CUTTING HEIGHT
WARNING: Failure to unplug your router before performing adjustments to
the router or table could result in accidental starting causing serious injury.
Select appropriate holes to adjust the router to the table according to Table 2
and Fig. 5.
NOTICE: A hex wrench is required Fig. 22
for this operation (not included).
1. Unplug the router.
2. Loosen the clamping lever on
the router.
3. Insert the hex wrench into the
adjusting hole on the tabletop
(Fig. 22), and turn the router
adjustment dial with the hex
wrench to move the router
collet down or up.
4. When the desired cutting height
is set, tighten the clamping lever on the router.
37599 Manual_Revised_12 1219 Page 23