Operation; Maintenance - Makita HM1111C Instruction Manual

1
011170
If the bit cannot be pushed in, remove the bit. Pull the
releasing cover down a couple of times. Then insert the
bit again. Turn the bit and push it in until it engages.
011171
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
011172
To remove the bit, pull the releasing cover down all the
way and pull the bit out.
Bit angle
1
011173
1. Releasing cover
1. Releasing cover
1
1. Change ring
011174
The bit can be secured at 12 different angles. To change
the bit angle, slide the change ring forward, then turn the
change ring to change the bit angle. At the desired angle,
slide the change ring back to the original position. The
bit will be secured in place.
NOTE:
The change ring cannot turn when the bit is not
•
installed on the tool.

OPERATION

Chipping/Scaling/Demolition
011176
Always use the D-shaped side handle or side grip
(auxiliary handle) and firmly hold the tool by both
D-shaped side handle or side grip and switch handle
during operations. Turn the tool on and apply slight
pressure on the tool so that the tool will not bounce
around, uncontrolled. Pressing very hard on the tool will
not increase the efficiency.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Lubrication
CAUTION:
This servicing should be performed by Makita
•
Authorized or Factory Service Centers only.
6