Washer/Dryer Maintenance - Maytag MET3800XW1 Use And Care Manual

Hide thumbs Also See for MET3800XW1:
Table of Contents

Advertisement

Available languages

Available languages

4,
Select
End of Cycle signal
(optional)
OFF
ON
Your dryer may have an End of Cycle signal, The signal is helpful
when drying items that should be removed from the dryer as
soon as it stops. The End of Cycle signal is part of the PUSH
TO START button and is selectable. Turn the PUSH TO START
button to ON or OFR The signal will sound only if the selector is
set to ON.
NOTE:
When the Wrinkle
Prevent setting
is selected
and the
End of Cycle
signal is on, the tone will sound
every 5 minutes
until the clothes
are removed
or the Wrinkle
Prevent setting
ends.
5,
Press PUSH TO START to
begin
cycle
(_°_
OFF
ON
\
/
PUSHTO START
end of cyde sigtta/
Push and hold the PUSH TO START knob to begin the cycle.
Promptly
remove
garments
after cycle has completed
to reduce
wrinkling.
Use the Wrinkle
Prevent feature to avoid wrinkling
when
you are unable to remove a load from the dryer as soon as it stops.
WASHER/DRYER
MAINTENANCE
r
WATER INLET HOSES
Replace
inlet hoses after 5 years of use to reduce
the risk of
hose failure. Periodically
inspect
and replace inlet hoses if
bulges,
kinks, cuts, wear, or leaks are found.
When
replacing
your inlet hoses,
mark the date of replacement
on the label with a permanent
marker.
WASH ER CARE
Recommendations
to Help Keep Your Washer
Clean and Performing at its Best
1. Always follow the detergent
manufacturer's
instructions
regarding
the amount
of detergent
to use. Never use more
than the recommended
amount
because
that may increase
the rate at which detergent
and soil residue
accumulate
inside
your washer, which
in turn may result in undesirable
odor.
2. Use warm and hot wash water settings
sometimes
(not
exclusively
cold water washes),
because
they do a better job
of controlling
the rate at which soils and detergent
accumulate.
3. Always
leave the washer
lid open between
uses to help dry
out the washer
and prevent
the buildup
of odor-causing
residue.
Cleaning
Your Top Loading Washer
Read these instructions
completely
before beginning
the
routine
cleaning
processes
recommended
below. This Washer
Maintenance
Procedure
should
be performed,
at a minimum,
once per month or every 30 wash cycles,
whichever
occurs
sooner, to control the rate at which soils and detergent
may
otherwise
accumulate
in your washer. To keep washer
interior
odor-free,
follow this recommended
monthly
cleaning
procedure:
affresh
_>Washer
Cleaner
Cycle
Procedure
(Recommended
for Best
Performance):
a. Open the washer
lid and remove any clothing
or items.
b. Place an affesh 'R; W asher
Cleaner
tablet
in the bottom
of
the washer
basket.
c. Do not add any detergent
or other chemical
to the washer
when following
this procedure.
d. Close the washer
lid.
e. Select
Normal Heavy cycle, Hot Temperature,
and High
Water Level.
f.
Pull out the Cycle knob. Water will pour into washer
for
a moment
and then pause; the lid will lock and the cycle
will continue.
NOTE:
For best results,
do not interrupt
cycle. If cycle must
be interrupted,
push in the Cycle
knob.
12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ymet3800xw2Ymet3800xw1Mgt3800xw3Met3800xw2Mgt3800xw2

Table of Contents