Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
Gather the required tools and parts before starting installation.
Tools
needed
•
Tape measure
•
Marker or pencil
•
Flat-blade screwdriver
•
Pipe-joint compound
resistant to LP gas
•
_sAe"combination
wrench
•
Pipe wrench
•
Noncorrosive leak-detection
solution
•
Channel lock pliers
Parts supplied
•
Gas pressure regulator
•
Burner grates
•
Burner bases and caps
•
Clamp brackets (2)
•
2Y2" (6.4 cm) clamping screws (2)
•
Foam tape seal
•
LP conversion kit - W10590568
Parts
needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements"
and
"Gas Supply Requirements"
sections.
IMPORTANT:
Observe all governing codes and ordinances.
Do
not obstruct flow of combustion
and ventilation air.
It is the installer's responsibility
to comply with installation
clearances specified on the model/serial rating plate. The
model/serial
rating plate is located on the underside of the
cooktop burner box.
To eliminate the risk of burns or fire by reaching over heated
surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood
that projects horizontally a minimum of 5" (12.7 cm) beyond
the bottom of the cabinets.
The cooktop should be installed in a location away from
strong draft areas, such as windows, doors and strong
heating vents or fans.
All openings in the wall or floor where cooktop is to be
installed must be sealed.
•
Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
Grounded electrical supply is required. See "Electrical
Requirements"
section.
Proper gas supply connection must be available. See "Gas
Supply Requirements"
section.
The gas and electric supply should be located as shown in
"Gas and Electric Connection
Locations" in the "Location
Requirements"
section so that they are accessible without
requiring removal of the cooktop.
REQUIREMENTS
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage.
Mobile
Home
- Additional
Installation
Requirements
The installation of this cooktop must conform to the
Manufactured
Home Construction
and Safety Standard, Title 24
CFR, Part 3280 (formerly the Federal Standard for Mobile Home
Construction
and Safety, Title 24, HUD Part 280). When such
standard is not applicable, use the Standard for Manufactured
Home Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this cooktop must conform with the
current standards CAN/CSA-A240-1atest
edition, or with local
codes.
Product Dimensions
_A
//,
///
I
A. 30" (76.2 cm) on 30" (76.2 cm) models
36" (91.4 cm) on 36" (91.4 cm) models
B. 21" (53.3 cm)
C. 3¼" (8.3 cm)
Gas and Electric Connection Locations
A
!
C
__
...............
B
D
A. Gas pressure regulator (supplied) - arrow pointed
toward cooktop
B. 3 prong grounding
type outlet with correct polarity
C. 18" (45. 7 cm) minimum
D. Gas shutoff valve
Advertisement
Table of Contents
