Step 1, Remove Packaging; Step 3, Install Water Line - GE ZIS360NXD Installation Instructions Manual

Installation Instructions
ISTEP 11 REMOVE PACKAGING
CAUTION:
The refrigerator is much heavier at
thetopthanatthebottom-be careful w hen moving.
When using a hand truck, handle from the side only.
PRUDENCE:
Le r6frig@ateur est beaucoup
plus Iourd en haut qu'en bas. II faut @treprudent Iors
des d@lacements. Si un diable est utilis6, il faut soulever
le r6frig6rateur sur le c6t6 seulement.
, Carefully cut banding at the top and bottom,
remove the outer carton.
, Slide out the back corner posts (2).
Slide the carton off the top of the cabinet.
NOTE: IT IS NOT NECESSARY TO LAYTHE CABINETDOWN
IN ORDERTO REMOVE THE SKID!
The unit is secured to the skid with 4 slotted
tie-down straps. Remove the six 7/16" bolts
from the base channels in the tie-downs.
Q
Q
, Remove the six 7/16"
bolts securing the straps
to the skid.
CAUTION" Do NOT
ATTEMPT TO ROLLUNIT
OFF SKID.
Remow
mie p aw, PRUDENCE: ,LNE
FAUTPAS ESSAYER DE FAIRE
_¢ ROULERLE REFRIGERATEUR
POURL'ENLEVERDE LAY
PALETTE.
The support blocks on the bottom of the refrigeration
case must be removed before the refrigerator is
taken off the skid or damage will occur. Carefully
tilt the refrigerator and slide the blocks out from
beneath.
Remove the toekick and set aside for final installation.
Lift the refrigerator off the skid with an appliance
dolly. Handle from the sides.
[STEP2 MOVE THE REFRIGERATOR INTO THE HOUSE
, Re-use the corner posts from the packaging to protect stainless steel models. Run the appliance dolly straps over
the posts and under the handles.
, Leave the protective film on the refrigerator until installation is complete.
IMPORTANT:Never lift the refrigerator by the handle or push against the grill panel; this could cause damage
or misalignment.
, Avoid laying the unit on its back or side to prevent sealed system restrictions.
ISTEP 3J INSTALL WATER LINE
, A cold water supply is required for automatic
icemaker operation. The water pressure must
be between 40 and 120 p.s.i.
, Route 1/4" OD copper or GE SmartConnect "
plastic tubing between house cold water line
and the water connection location.
, The tubing should be long enough to extend
to the front of the refrigerator. Allow enough tubing
to accommodate the bend leading into the water line
connection.
NOTE:The only GE approved plastic tubing is supplied
in the GE SmartConnect T"Refrigerator Tubing kits.
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types
of plastic may crack or rupture with age and cause
water damage to your home.
GE SmartConnect " Refrigerator Tubing Kits are
available in the following lengths:
2' (.6 m) WXO8XIO002
6' (1.8 m) WXO8XIO006
15' (4.6 m) WXO8X10015
25' (7.6 m) WXO8X10025
_Cold WaterLine
11